|
|
![]() Fly Tier: Richardt Jensen |
|
Tying Instruction : 1) Tie on thread near the front of the tube. 2) Tie on oval tinsel and wrap a smooth thread underbody back to the end of the tube. 3) Tie on silver tinsel and wrap a smooth thread underbody back to the front of the tube. 4) Wrap the body with the flat silver tinsel and rib it with the oval tinsel. 5) Tie a white wing on the under side of the tube. 6) On the top of the tube first tie on pear crystal flash then yellow craft fur and then light blue craft fur to create the top wing. 7) Tie on a white saddle hackle or schlappen and wrap a white collar. 8) Tie a neat head and whip finish. 9) Remove the tube fly from the vise. 10) Cut a small piece of modeling compound ( Sculpey III or Plasticine) approximately 2 inches square by 1/2 inch thick. Take a ballpoint pen or marker with a conical tip and press it into the compound, do not go all of the way through. This depression will be the mold for the head of the fly. Take a Q-tip and coat the inside of the depression with Vaseline, this will keep the hot glue from sticking to the mold. Fill the depression with hot glue from a hot glue gun and take your finished tube fly and push it head first through the hot glue. Give the glue a minute or so to harden and remove the fly. You can now paint on eyes or use stick on eyes and coat the head with hard as nails. This process is easier and quicker than it sounds just tie the flies ahead of time and use a couple of pieces of modeling compound to make several heads all at once. Note : Use this technique on your favorite tube fly. |
|
| ||
|