|
|
![]() Fly Tier: Andrew Cooper |
|
Tying Instruction : 1) Make a splayed tail with the Microfibetts. 2) Tie in Goose Biot by its tip and wind forward to form a smooth abdomen. 3) Strip the barbs from both sides of 2 CDC feathers. To do this hold 2 matched feathers together. Now strip the barbs off of one side of both feathers by holding the barbs between the fore finger and the thumb and cutting along the stem. 4) Form the barbs into a bunch and place a 2 inch long piece of poly yarn on top of them. 5) Place the combination of poly yarn and CDC at the front of the hook where you'd like to form the wing. Make sure the CDC is on the bottom of the pile. 6) Tie in the CDC and the poly yarn the same way you would make spinner wings. Use a cross over pattern. Don't do more than 2 wraps for each cross. 7) Now grasp the entire stack of CDC and poly yarn and pull straight up. Wrap thread clockwise around the stack to form the wing post. 8) Leave the wing standing straight up and form a small thorax with super fine dubbing underneath the wing. 9) Whip finish head. 10) Hold on to poly yarn with one hand and pull the CDC barbs below the hook with the other. Holding the CDC barbs cut them off at about 1 & 1/2 times the hook gap. 11) Lift up on the poly and cut a wing about 1 hook length long. |
|
| |||||
|